

Provides instant replacement for lost fillings with its zinc oxide based material, ensuring quick dental repair. This pre-mixed temporary tooth filling is ready for use and includes a spatula for easy application. Ideal for emergency dental care when professional help is not immediately available.
Net Content: 3 Grams.
Ingredients: Zinc oxide based material.
Features: Instantly replaces lost fillings. Pre mixed ready for use. Spatula included. Sufficient for around 10 fillings.
Storage Conditions: Max Temp 25°C, Min Temp 4°C.
Safety Warning: Important - Tooth filling is not an adhesive and will not bond to the surface of the tooth. The cavity must have sufficient undercut for the material to key into position and to hold in place once hardened.
Avoid over-filling the cavity with tooth filling material as this may cause a high point. This high point may result in undue pressure on the material during chewing or eating, causing it to crumble.
To allow material to harden correctly, gently close jaws in a comfortable position for around 15 minutes and avoid over salivation and touching the material with the tongue.
Temporary tooth filling material is not intended to last more than 28 days in the mouth.
Preparation and Usage Instructions:
1. Place a small amount of tooth filling into cavity and gently bite into place, or use enclosed spatula to pack material into cavity.
2. Do not over fill cavity as any high points, protruding into the biting area, may cause temporary filling to crumble. The correct amount will allow jaws to close normally, without teeth from opposing jaw touching the material.
3. Avoid biting, chewing or over salivation for 15 minutes.
4. Always seek qualified dental advice as soon as possible and do not use for very large or very painful fillings.
5. Do not put unused material back into container.
6. In low temperatures material may harden in container and become difficult to remove from the tube, soften by warming container in hand before use.
7. Replace cap securely after use.
Consult instructions before use and carefully read all the information on this pack.
Storage Type: Ambient.
Third Party Logo: CE Mark - European Conformance.
Medical Devices.
Manufacturer Address: GAP Research Company Ltd., Northfleet, Kent, UK. Denvtech Ltd., Ground floor, 8-9 Marino Mart, Fairview, Clontarf, Dublin 3, D03 P590.